Touch Setup ​

This is an important step when setting up a computer with multiple displays where one or more of those displays are touch-enabled. This step is required because touch screens are almost always two devices in one: the display itself and the touch input device. While these two devices may be in the same enclosure, they are connected separately to the computer via a combination of USB cable and some display cable such as DisplayPort or HDMI.

The touch setup procedure can be skipped when any of the following are true:

• The setup has no touch screens.
• The setup only has a single screen, even if it supports touch.

In all other situations, touch interactions will not be properly handled until touch setup is complete.

1. Ensure all displays are connected to the GPU, and that all touch screens are also connected via USB.
2. Access the isotope web console via browser. See Finding the Computer.
3. Navigate to the SETUP tab.
4. Click the Touch Setup button.
5. As each touch screen lights up, tap it once. The highlight will move to the next screen. If you have displays that are not touch-enabled, you may press the Skip button in the web browser to skip to the next display.

If there were any problems during the touch setup procedure, it is safe to repeat the procedure until it has been completed successfully. Once complete, the configuration will be saved.